西安尚平电子科技有限公司

as noted.  (5% and 20% are available for most resistance values)

Specifications:
Temperature Coefficient for MP915, MP916, 
MP925, and MP930:
TC referenced to +25°C, ΔR taken at +150°C
0.50 ohms and above, -20 to +80 ppm/°C
0.050 ohm to 0.49 ohms, 0 to +200 ppm/°C
0.020 ohm to 0.049 ohm, 0 to +300 ppm/°C
0.010 ohm to 0.019 ohm, 0 to +500 ppm/°C
Temperature Coefficient for MP9100:
TC referenced to +25°C, ΔR taken at +175°C
0.50 ohms and above, -20 to +80 ppm/°C
0.050 ohm to 0.49 ohms, 0 to +150 ppm/°C
Operating Temperature:  -55°C to TMAX
Inductance:  MP915, MP916, MP925, and MP930  
10nH typical; MP9100, 20nH typical, in series when 
measured at a point 0.2 inches from the resistor 
body.
DWV:  The dielectric strength rating of 1500 VrmsAC 
is based upon connections made between 
terminals shorted, and the metal surface the part is 
mounted to or a metal clip in contact with the top 
surface of the part.
Insulation Resistance:  10,000  Megohms  min.
The resistor element is electrically isolated from 
the mounting surface.
Load Stability:  2,000 hours at rated power. 
ΔR ±(1.0 percent + 0.0005 ohm) max. Power 
rating dependent upon case temperature. See 
derating curve. 
Momentary Overload: 1.5 times rated power with 
applied voltage not to exceed 1.5 times maximum 
continuous operating voltage for 5 seconds. ΔR 
±(0.5 percent + 0.0005 ohm) max.
Moisture Resistance: Mil-Std-202, Method 106.
ΔR ±(0.5 percent + 0.0005 ohm) max.
Thermal Shock:  Mil-Std-202, Method 107, Cond. F. 
ΔR ±(0.5 percent + 0.0005 ohm) max.
Shock: 100G, Mil-Std-202, Method 213, Cond. I.
ΔR ±(0.4 percent + 0.0005 ohm) max.
Vibration, High Frequency:  Mil-Std-202, Method 
204, Cond. D.  ΔR ±(0.4 percent + 0.0005 ohm) 
max.
Terminal Strength:   Mil-Std-202, Method 211, 
Cond. A (Pull Test) 5 lbs. ΔR ±(0.2 percent 
+ 0.0005 ohm) max.
Terminal Material:  Solderable
Measurement Note:  For these specifications, 
resistance measurement shall be made at a point 
0.2 inch (5.08 mm) from the resistor body